Services / Installation & commissioning
Installation and commissioning of ultrafast laser systems
A new system, a lab move or a restart after renovation: we prepare the lab, install the laser, bring it to its specification and document that it gets there.
Before the system arrives
Preparing the lab
Most installation problems are decided before the crates are opened. We go through the site requirements with you and check them in the room.
- Lab conditions
- Temperature and humidity stability, vibration, cleanliness and laminar flow, checked against what the system actually needs.
- Infrastructure
- Cooling water and chillers, electrical supply, table space and beam heights.
- Layout
- Where each stage sits on the table, how the beam reaches your experiment, and room to work on it later.
Installation
From the crate to specification
We set up and align the chain from the oscillator through the amplifier to the OPA, bring each stage to its specified output, and integrate the laser with your experiment: beam transport, synchronisation and diagnostics.
For a new system under manufacturer warranty, we work alongside the manufacturer's installation: preparing the lab, checking the acceptance measurements and connecting the laser to your setup.
Relocation
Moving a system
A laser that met its specification before a move should meet it afterwards. We record the performance before shutdown, plan the disassembly and transport, reinstall and realign in the new lab, and measure again — so you can see the system arrived in the state it left.
Acceptance
Documented against the specification
Commissioning ends with measurements against the specification sheet — power, pulse duration, spectrum, beam quality and stability — written up as a protocol. See characterisation for the measurements, and consulting if you want support with the acceptance of a new purchase.